Reobijn Plastics chooses for Durability

Reobijn Plastic Products in Haaksbergen has recently installed NTZ Micro filtration systems on all of their injection moulding equipment.

Frans Dijkhof, technical director at Reobijn: “within our preventive maintenance schedule we take annual oil samples.” Clean oil is crucial within our production process, Reobijn uses 2 k tons injection moulding equipment and contamination causes major problems in lining up our injection equipment resulting in rejects.

The last oil analyses showed severe contaminated oil and it was advised to flush and do an oil change. However Chemically the oil was in a good condition, so we decided to test the NTZ Micro Filtration System. The test was closely obeserved and an oil sample was taken and analized every 24 hours. Already after the first 24 uur all 200 gallons of the oil were within specifications again and suitable for further use according to the Laboratory reports. After 168 hours solid particle and water contamination were reduced by 98 % and the ISO code of 14/12/09 is even better than the new Hydraulic fluid as supplied to Reobijn.

Now the NTZ Micro Filtration Systems are installed on all of our equipment saving materials, labor/down time and significantly increasing the reliabillity and quality.